Svedén Organization
Mount the X-axis motor end
| Required parts | Part ID | Required number |
|---|---|---|
| Z-axis nut | No.18 | 1 |
| X-axis motor end | No.M1 | 1 |
| Linear Bearing | No.38 | 1 |
| M3 x 30 screw | No.29 | 1 |
| M3 x 6mm screw | No.23 | 8 |
| M3 washer | No.7 | 2 |
| Spring | No.35 | 1 |
| End stop | No.46 | 1 |
| M2.5 x 12 screw | No.17 | 2 |
| M2.5 washer | No.6 | 2 |
Step 1. Mount the Z nut on the X-axis left end from bottom to up, fix with M3 x 6mm screws.
Step 2. Mount the linear bearing on X-axis motor end from bottom to up. Fix it up with M3 x 6mm screws.
Mount the endstop trigger
Step 1. Thread a M3 washer> spring> M3 washer in order to the M3x30mm screw.
Step 2. Thread half of the M3x30mm screw into the screw hole.